Zc Shroud Assembly And Installation - kozy heat Jackson 911XXL Installation And Operation Manual

ZC SHROUD ASSEMBLY AND INSTALLATION

Shroud assembly includes: (1) Shroud top
(1) Shroud left side
(1) Shroud right side with on/off rocker switch mounting hole
You will need the following items from insert components packet: Rocker Switch Wires and On/Off Rocker Switch.
You will also need a grill set (sold separately).
1. Remove nuts from upper grill. Place grill rods through holes in shroud top section. Secure with nuts. If necessary, recess upper grill
by re-positioning in one of three mounting holes.
2. Secure right and left shroud sections to top section by aligning (2) holes in side sections to holes in top section. Secure with phillips
head screws (2 ea. side).
OPTIONAL: Attach shroud extensions by aligning slots in shroud with desired hole in shroud extension. Secure with phillips head screws.
Assemble shroud with phillips head screw
Figure 19a
3. Snap rocker switch into place on shroud.
4. Slide one connector on each rocker switch wire to the rocker switch.
5. Attach shroud to insert by placing tabs on left and right shroud pieces into slots in insert. The shroud will set into place.
6. Slide remaining connectors on rocker switch wires to terminals on gas valve marked TH and THTP.
7. Remove nuts from lower grill, insert grill bolts through lower hinges on insert. Attach and tighten nuts.
Figure 19b
(8) Phillips head screws
(2) Shroud extensions
Attach grill in desired holes
Attach shroud extensions by aligning
Slot in shroud with desired hole in shroud
Extension. Secure with phillips head screws
provided.
PAGE 19