Table of Contents
Advertisement
Line Settings
Baud Rate
Parity
Data Bits
Stop Bits
Flow Control
Xon Char
Xoff Char
Gap Timer
Threshold
Command Mode
Line Command
Mode Settings
Mode
Wait Time
PremierWave XC User Guide
Description
Sets the Baud Rate (speed) of the Line. The default is 9600.
Any set speed between 300 and 921600 may be selected: 300, 600, 1200, 2400,
4800, 9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600. When
selecting Custom baud rate (available for line 1 and line 2 only), you may manually
enter any value between 300 and 5000000.
Sets the Parity of the Line. The default is None.
Sets the number of data bits for the Line. The default is 8.
Sets the number of stop bits for the Line. The default is 1.
Sets the flow control for the Line. The default is None.
Set Xon Char to be used when Flow Control is set to Software. Prefix decimal with \
or prefix hexadecimal with 0x or prefix a single control character <control>.
Set Xoff Char to be used when Flow Control is set to Software. Prefix decimal with \
or prefix hexadecimal with 0x or prefix a single control character <control>.
Set the Gap Timer delay to Set the number of milliseconds to pass from the last
character received before the driver forwards the received serial bytes. By default,
the delay is four character periods at the current baud rate (minimum 1 ms).
Set the number of threshold bytes which need to be received in order for the driver to
forward received characters.
Table 7-2 Line Command Mode Settings
Description
Sets the Command Mode state of the Line. When in Command Mode, a CLI session
operates exclusively on the Line. Choices are:
Always
Use Serial String
Disabled
Note:
In order to enable command mode on the Line, Tunneling on the Line must be
Disabled (both connect and accept modes).
Enter the amount of time to wait during boot time for the Serial String. This timer
starts right after the Signon Message has been set on the Serial Line and applies only
if mode is "Use Serial String".
7: Line and Tunnel Settings
47
Advertisement
Table of Contents
Troubleshooting
