Line Command Mode; Figure 9-3. Line N Command Mode - Lantronix EDS32PR User Manual

Line Command Mode

Setting Command Mode enables the command line interface (CLI) on the serial line.
Configure Line n Command Mode:
1. Click Line n and Command Mode. The Line n Command Mode page appears.
2. Enter or modify the following settings:
Line -
Command Mode
Page Settings
Mode
Wait Time
Serial String
EDS User Guide
9: Line, Tunnel, Terminal, and Host Settings

Figure 9-3. Line n Command Mode

Description
Select the method of enabling Command Mode or choose to
disable Command Mode.
Always = immediately enables Command Mode for the serial
line.
Use Serial String = enables Command Mode when the serial
string is read on the serial line during boot time.
Disabled = turns off Command Mode.
Enter the wait time for the serial string during boot-up in
milliseconds.
Enter the serial string characters. Select a string type.
Text = string of bytes that must be read on the Serial Line
during boot time to enable Command Mode. It may contain a
time element in x milliseconds, in the format {x}, to specify a
55