To View Or Configure Syslog Settings; Http Settings; Table 9-4 Http Settings - Lantronix PremierWave XC User Manual

To View or Configure Syslog Settings

Using Web Manager

To configure the Syslog, click Syslog in the menu bar.
Using the CLI

To enter the Syslog command level: enable -> config -> syslog
Using XML

Include in your file: <configgroup name="syslog">

HTTP Settings

Hypertext Transfer Protocol (HTTP) is the transport protocol for communicating hypertext
documents on the Internet. HTTP defines how messages are formatted and transmitted. It also
defines the actions web servers and browsers should take in response to different commands.
HTTP Authentication enables the requirement of usernames and passwords for access to the
device.
HTTP Settings
State
Port
Secure Port
Secure Protocols
Secure Credentials
Max Timeout
Max Bytes
PremierWave XC User Guide

Table 9-4 HTTP Settings

Description
Select Enabled or Disabled for the state of the HTTP server.
Enter the port for the HTTP server to use. The default is 80.
Enter the port for the HTTPS server to use. The default is 443. The HTTP
server only listens on the HTTPS Port when an SSL certificate is configured.
Select to enable or disable the following protocols:

SSL3 = Secure Sockets Layer version 3

TLS1.0 = Transport Layer Security version 1.0. TLS 1.0 is the successor of
SSL3 as defined by the IETF.

TLS1.1 = Transport Layer Security version 1.1
The protocols are enabled by default.
Note: A server certificate and associated private key need to be installed in
the SSL configuration section to use HTTPS.
Specify the name of the set of RSA and/or DSA certificates and keys to be
used for the secure connection.
Enter the maximum time for the HTTP server to wait when receiving a
request. This prevents Denial-of-Service (DoS) attacks. The default is 10
seconds.
Enter the maximum number of bytes the HTTP server accepts when receiving
a request. The default is 40 kB (this prevents DoS attacks).
9: Services Settings
63