Line Command Mode; Figure 6-4 Line 1 Command Mode; Table 6-5 Line Command Mode - Lantronix XPortPro User Manual

Line Command Mode

Setting the Command Mode
enables the CLI on the serial
line.
To configure Command
Mode on a specific line:
1. Select Line on the menu
bar, if you are not already
in the Line web page.
2. Select a line number at the
top of the page.
3. Select Command Mode.
The Command Mode page
for the selected line
appears.
4. Enter or modify the following settings:
Line – Command Mode
Settings
Mode
Wait Time
XPort Pro User Guide
Line Command Mode
Table 6-5
Description
Select the method of enabling Command Mode or choose to disable Command
Mode.
Always = immediately enables Command Mode for the serial line.

Use Serial String = enables Command Mode when the serial string is read

on the serial line during boot time.
Use CP Group = enables Command Mode based on the status of a CP

Group. When the value matches the current value of the group, Command
Mode is enabled on the serial line.
Use both Serial String and CP Group = the serial string and the value of

the CP group must be matched to enable Command Mode.
Disabled = turns off Command Mode.

Enter the wait time for the serial string during boot-up in milliseconds.
6: Line and Tunnel Settings

Figure 6-4 Line 1 Command Mode

35