To Configure Line Settings; Using Web Manager; Using The Cli; Using Xml - Lantronix EDS-MD EDS-MD4 User Manual

Line Command
Mode Settings
Mode
Wait Time
Serial String
Echo Serial String
Signon Message

To Configure Line Settings

Note: The following section describes the steps to view and configure Line 1 settings;
these steps apply to other line instances of the device.

Using Web Manager

To configure a specific line, click Line in the menu and select Line 1 -> Configuration

6-1).
To configure a specific line in Command Mode, click Line in the menu and select Line 1 ->

Command Mode

Using the CLI

To enter Line 1 command level: enable -> line 1


Using XML

Include in your file: <configgroup name="line" instance="1">

Include in your file: <configgroup name="serial command mode" instance="1">


To View Line Statistics

Using Web Manager
To view statistics for a specific line, click Line in the menu and select Line 1 -> Statistics.

EDS-MD User Guide

Table 6-2 Line Command Mode Settings

Description
Set the Command Mode state of the Line. When in Command Mode, a CLI session
operates exclusively on the Line. Choices are:
Always

User Serial String

Disabled

Note: In order to enable Command Mode on the Line, Tunneling on the Line must
be Disabled (both Connect and Accept modes). Also, custom baud rates are not
supported in Command Mode.
Enter the amount of time to wait during boot time for the Serial String. This timer
starts right after the Signon Message has been set on the Serial Line and applies
only if mode is "Use Serial String".
Enter the Text or Binary string of bytes that must be read on the Serial Line during
boot time in order to enable Command Mode. It may contain a time element to
specify a required delay in milliseconds x, formed as {x}. Applies only if mode is
"User Serial String". It may contain a binary character(s) of the form [x]. For
example, use decimal [12] or hex [0xc].
Select Enable or Disable for Echo Serial String. Applies only if mode is "User Serial
String". Select enable to echo received characters backed out on the line while
looking for the serial string.
Enter the string of bytes to be sent to the Serial Line during boot time. It may contain
a binary character(s) of the form [x]. For example, use decimal [12] or hex [0xc].
(Table 6-2).
6: Line and Tunnel Settings
(Table
36