Line Command Mode; Figure 9-4 Line 1 Command Mode; Table 9-5 Line Command Mode - Lantronix EDS32PR User Manual

Line Command Mode

Setting the Command Mode
enables the CLI on the serial
line.
To configure Command
Mode on a specific line:
1. Select Line on the menu
bar, if you are not already
in the Line web page.
2. Select a line number at the
top of the page.
3. Select Command Mode.
The Command Mode page
for the selected line
appears.
4. Enter or modify the following settings:
Line – Command Mode
Settings
Mode
Wait Time
Serial String
Echo Serial String
EDS User Guide
Line Command Mode
Table 9-5
Description
Select the method of enabling Command Mode or choose to disable
Command Mode.
Always = immediately enables Command Mode for the serial line.

Use Serial String = enables Command Mode when the serial string is

read on the serial line during boot time.
Disabled = turns off Command Mode.

Enter the wait time for the serial string during boot-up in milliseconds.
Enter the serial string characters. Select a string type.
Text = string of bytes that must be read on the Serial Line during boot

time to enable Command Mode. It may contain a time element in x
milliseconds, in the format {x}, to specify a required delay.
Binary = string of characters representing byte values where each

hexadecimal byte value starts with \0x and each decimal byte value starts
with \.
Select Yes to enable echoing of the serial string at boot-up.
9: Line and Tunnel Settings

Figure 9-4 Line 1 Command Mode

55