Adjusting The Print Bias For Print Quality - Intermec 3600 Maintenance Manual

3600 Printer Maintenance Manual
c 3 9 frank c 3 9

Adjusting the Print Bias for Print Quality

Adjust the bias with a straight-slot screwdriver if the printhead is not making
even contact with the media. Using different width media, especially narrow
media, can result in uneven contact or a spot where there is no media between
the printhead and the platen roller. Extra wear and damage can occur if narrow
media is used for extended periods with incorrect bias.
To adjust the bias adjust screw
1. Remove the media cover and locate the bias adjust screw.
2. Turn the bias adjust screw counterclockwise to compensate for light print
3. Install the media cover.
3-14
on the right side of the label; turn the bias adjust screw clockwise to
compensate for light print on the left side.
If printing is light on
the right side of label,
turn the bias adjust screw
counterclockwise.
Printhead bias
adjust screw
3600M.030
If printing is light on
the left side of label,
turn the bias adjust screw
clockwise.
3600M.031