Intermec 3600 Maintenance Manual page 109

Snap
ring
Platen
Washer
roller
gear
Tear bar
Tear bar
support
To replace the platen roller and platen roller gear
1. Loosen the motor as necessary to mesh the platen roller gear with the
motor pinion gear and TTR drive gear/pulley upon reassembly.
2. Install the washer removed in Step 6 and a new retaining E-ring on the
platen roller and insert it through the main deck plate and into the washer
removed in Step 4 and the platen drive gear.
3. Reassemble the tear bar and bar support, and then install the lower
outboard plate, securing the tear bar assembly and the rollers.
Note: Use the roller alignment tool during reassembly to align the outboard plate.
4. Secure the platen drive gear with a new retaining ring and slide the motor
forward to mesh the motor pinion gear with the platen drive gear and the
liner drive gear/pulley. Turn the TTR roller drive gear to check for proper
gear engagement and tighten the motor mounting screws.
5. Reattach the front bezel cover. Ensure that the media access door operates
properly (snaps firmly shut) after the front bezel cover is installed.
6. Reload media (and ribbon if used) and lower the printhead.
7. Install the electronics cover, the media cover, and the power cord, and
check the printer for proper operation.
Remove and Replace Procedures
E-ring
Platen
roller
5
Lower
outboard
plate
3600M.057
5-23