Intermec 3600 Maintenance Manual page 68

3600 Printer Maintenance Manual
c 3 9 frank c 3 9
4. Install the printhead alignment tool and press the printhead assembly
5. Alternately tighten the two 9/64 inch printhead yoke screws until secure.
6. Remove the printhead alignment tool.
7. Return the printhead adjustment lever to the neutral/center position.
8. Reload media (and ribbon if used).
9. Install the media cover and the power cord.
10. Switch on printer power and test for proper printhead alignment by
3-24
Note: This is a change in procedure from previous printhead alignment
instructions that directed the printhead adjustment lever to be in the neutral/center
position during alignment.
down on the platen roller. Align the tool with the notches in the heat sink
and the printhead.
printing out the print quality and pitch labels.
Printhead
alignment
tool
Place the cutouts
of the printhead
alignment tool onto
the shaft of the platen
roller.
Printhead
alignment
tool
Guide pin
(Align with the notches
on the heatsink and printhead.)
Heatsink
Notch
I n t e
r m e
c
3 6
0 0
Printhead
lift lever
3600M.040