Intermec 3600 Maintenance Manual page 114

3600 Printer Maintenance Manual
To replace liner reverse gear 2, the liner takeup clutch/pulley, liner reverse shaft,
liner drive gear/pulley, and liner drive belt
1. If not already done, perform Steps 1 through 5 of the preceding liner roller
2. Remove the retaining snap ring that holds the liner reverse shaft, takeup
5-28
replacement procedure.
clutch/pulley, and reverse gear 2 in place. Retain the washer located
between the snap ring and subplate. Discard the old snap ring.
Lower
drive
belt
Liner
reverse
gear
Subplate
Liner
reverse
gear
Liner drive
gear/pulley
Liner takeup
clutch/pulley
assembly
Motor
plate
Snap ring
Thin Liner
washer reverse
gear
Liner
drive
roller
Liner
drive
roller
Liner
reverse
shaft
Snap ring
Thin
washer
3600M.060