Cleaning The Rollers And Tear Bar - Intermec 3600 Maintenance Manual

3600 Printer Maintenance Manual

Cleaning the Rollers and Tear Bar

Cleaning the platen roller and the tear bar preserves print quality by ensuring
close contact between the media and the printhead. The TTR roller, liner roller,
and media roller are cleaned in the same fashion to minimize general debris
and to maximize their efficiency.
To clean the rollers and tear bar
1. Remove the media cover.
2. Raise the printhead by rotating the head lift lever clockwise until the
3. Remove the media from the paper path and the ribbon (if installed) from
4. Clean the rollers with a lint-free cloth moistened in isopropyl alcohol. Wipe
5. Clean both sides of the tear bar with a lint-free cloth moistened in isopropyl
6. Reload the media (and ribbon if used) and then engage the printhead by
7. If you are finished cleaning, install the media cover.
2-8
printhead releases.
the TTR hubs.
the cloth over the rollers, rotating each roller so that you clean all of it.
TTR
roller
I n t e
r m e
c
3 6
0 0
alcohol. Remove all traces of dust, paper, and adhesive.
turning the head lift lever counterclockwise until the printhead locks.
Media roll
roller
Platen
roller
Tear
Liner
bar
roller
3600M.013