Replacing The Lithium Battery - Intermec 3600 Maintenance Manual

3600 Printer Maintenance Manual

Replacing the Lithium Battery

To replace the lithium battery, you will need the following parts and tools:
Warning
There is danger of explosion if the battery is incorrectly replaced. Replace
it only with the same or equivalent type battery recommended by the
WARNING
manufacturer. Discard used batteries according to the manufacturer's
instructions.
Il y a danger d'explosion s'il y a remplacement incorrect de la batterie.
Remplacer uniquement avec une batterie du même type ou d'un type
recommandé par le constructeur. Mettre au rébut les batteries usagées
conformément aux instructions du fabricant.
To replace the lithium battery
Note: The printer will lose data if the battery fails or is removed. Before removing the
battery, upload and save the fonts, formats, pages, graphics, and configuration settings.
1. Switch off the printer power and remove the power cord, the media cover,
2. Remove the old battery and install the new battery, matching the (+) and (-)
3. Install the covers and power cord. Check the printer for proper operation.
5-4
1.75AH 3.6V AA lithium battery, Intermec Part No. 586229
ESD grounding strap
#2 Phillips screwdriver
and the electronics cover.
ends of the battery with the (+) and (-) signs on the main PCB.
Lithium
battery
J 9
Main PCB
0 0
3 6
3600M.042