Intermec 3600 Maintenance Manual page 100

3600 Printer Maintenance Manual
6. Use a small straight-slot screwdriver to lift up on each of the two molded
7. Slide the upper media guide plate back together with the lower media
8. Route the label gap sensor cable through the cutout in the main deck plate
9. Attach the label gap sensor cable to the main PCB.
10. Reload media (and ribbon if used) and lower the printhead.
11. Install the electronics cover, the media cover, and the power cord, and
5-14
Label
gap
sensor
Lower
media
guide
tabs that secure the label gap sensor. Slide the label gap sensor from its
housing and replace it with the new label gap sensor. The label gap sensor
should snap into place.
guide plate.
and reattach the media guide assembly to the frame. Be sure that the media
brake arm does not rub on the upper media guide and that the sensor cable
is not contacting any moving parts.
check the printer for proper operation.
Upper
media
guide
Locking
tabs
Lift spring
Label gap
sensor
housing
3600M.052