Replacing The Transformer - Intermec 3600 Maintenance Manual

4. Compress the tabs that hold the power switch secured to the back plate and
5. Install the power switch by pushing the new receptacle into the cutout in
6. Reattach the two push-on connectors removed in Step 3.
7. Install the electronics cover, the media cover, and the power cord, and

Replacing the Transformer

To replace the transformer, you will need the following parts and tools:
Note: The printer uses a different transformer for 220-volt and 115-volt printers.
To replace the transformer
1. Switch off the printer power and remove the power cord, the media cover,
2. Disconnect the transformer cable from the main PCB and the two leads
push it out of the main deck plate.
the main deck plate.
check the printer for proper operation.
XFMR, 3600, 47-63HZ, 100V/120V, Intermec Part No. 585525-001 or
XFMR, 3600, 47-63HZ, 200V/240V, Intermec Part No. 585525-002
ESD grounding strap
#2 Phillips screwdriver
and the electronics cover.
with push-on connectors from the AC power plug and the power switch.
Transformer
Screw
(2 places)
Remove and Replace Procedures
Power switch/
circut breaker
Main PCB
AC power
plug
3600M.064
5
5-33