Replacing The Label Gap Sensor - Intermec 3600 Maintenance Manual

Replacing the Label Gap Sensor

To replace the label gap sensor, you will need the following parts and tools:
To replace the label gap sensor
1. Switch off the printer power and remove the power cord, the media cover
2. Raise the printhead. Remove media and ribbon if loaded.
3. Disconnect the label gap sensor cable from the main PCB.
4. Remove the three screws securing the upper/lower media guide assembly
5. Slide the upper media guide outward to separate it from the rest of the
Label gap cable assembly, Intermec Part No. 059495-001
ESD grounding strap
Small straight-slot screwdriver
12-inch shank #2 Phillips screwdriver
and the electronics cover.
Gap sensor
cable
Label gap
sensor
Upper and lower
media guide assembly
to the main deck plate.
assembly.
Remove and Replace Procedures
5
3600M.051
5-13