3600 Printer Maintenance Manual
Replacing the TTR Takeup Hub, Clutch/Pulley, and Belt
To replace the TTR takeup hub, TTR takeup clutch/pulley, and TTR takeup
drive, you will need some or all of the following parts and tools:
To remove the TTR takeup hub, TTR takeup clutch/pulley, and TTR drive belt
1. Switch off the printer power and remove the power cord.
2. Remove the media supply cover, the electronics cover, and the front bezel
3. Raise the printhead. Remove media and ribbon if loaded.
4. Remove the two TTR takeup clutch/pulley retaining snap rings and the
5-18
TTR takeup hub, Intermec Part No. 061562-005
TTR takeup clutch assembly, Intermec Part No. 062927S-001 (white)
2.800ID x .210 drive belt (O-ring), Intermec Part No. 501462-003
Retaining snap rings, Intermec Part No. 501410
ESD grounding strap
Snap ring pliers
#1 and #2 Phillips screwdriver
cover (refer to "Replacing the Bezel PCB" earlier in this chapter).
thick washer from the end of the TTR takeup hub shaft. Retain the washer.
Discard the old snap rings.
TTR takeup
drive belt
Thick
washer
Snap ring
TTR clutch/
pulley
Thin washer
TTR takeup
hub
TTR drive
gear/pulley
3600M.055