Intermec 3600 Maintenance Manual page 112

3600 Printer Maintenance Manual
6. You can replace the liner takeup hub and/or liner reverse gear 1 now.
7. Install the thick washer removed in Step 5 between the liner takeup hub
8. Insert the liner takeup hub through the main deck plate, reverse gear 1, and
9. Reattach the front bezel cover. Ensure that the media access door operates
10. Reload media (and ribbon if used) and lower the printhead.
11. Install the electronics cover, the media cover, and the power cord, and
To replace the liner drive roller
1. If not already done, switch off the printer power and remove the power
2. Remove the five screws that secure the lower outboard plate to the main
5-26
and the main deck plate. Position liner reverse gear 1 between the motor
plate and the liner takeup subplate and check for proper engagement with
liner reverse gear 2.
the subplate. Install the washer removed in Step 4 on the hub shaft
extending through the subplate and secure with two new snap rings.
properly (snaps firmly shut) after the front bezel cover is installed.
check the printer for proper operation.
cord, media cover, electronics cover, and the front bezel cover. Raise the
printhead and remove the media and ribbon if loaded.
deck plate and pull the plate away from the rollers. The tear bar and tear
bar support come loose when the outboard plate is removed. Retain them
for reassembly.
Snap
ring
Tear bar
Tear bar
support
Washer
Liner drive
gear/pulley
E-ring
Liner drive
roller
Lower
outboard
plate
3600M.059