Replacing The Stepper Motor - Intermec 3600 Maintenance Manual

3600 Printer Maintenance Manual

Replacing the Stepper Motor

To replace the stepper motor, you will need the following parts and tools:
To replace the stepper motor
1. Switch off the printer power and remove the power cord, the media cover,
2. Unplug the motor cable from the main PCB and remove the motor from the
3. Mount the new motor loosely to the motor plate with the cable positioned
4. Plug the motor cable into the main PCB. Check that the motor cable-to-
5. Install the electronics cover, the media cover, and the power cord, and
5-30
Main stepper motor and cable assembly, Intermec Part No. 061551-002
ESD grounding strap
#2 Phillips screwdriver
and the electronics cover.
motor plate and motor mount bracket.
Main PCB
Screw
(3 places)
at the bottom rear corner. Properly mesh the pinion gear with the platen
drive gear and the liner drive gear before tightening the screws completely.
main PCB connection is correctly aligned before applying power to avoid
damaging the main PCB.
check the printer for proper operation.
J 9
Do not install
a screw in this
Stepper
Motor
mounting hole.
motor
plate
3600M.061