Cleaning The Printer Covers - Intermec 3600 Maintenance Manual

3600 Printer Maintenance Manual
10. Reload the media (and ribbon if used).
11. Engage the printhead by rotating the head lift lever counterclockwise until
12. If you are finished cleaning, install the media cover.
2-12
5. Pull down on the lower media guide to expose the label gap sensor. Using
a soft bristle brush, remove all debris and dust from the label gap sensor.
6. Clean the label gap sensor with a cotton swab and alcohol.
7. Remove the electronics cover.
8. Very carefully clean the small ribbon motion optical sensor on the main
PCB and the black and white encoder decal on the TTR supply
clutch/encoder assembly with a cotton swab moistened with alcohol.
9. Install the electronics cover.
it locks in place.

Cleaning the Printer Covers

Clean the 3600 printer covers with a general purpose cleaner (soapy
water/mild detergent). Do not use abrasive cleansers or solvents. Be sure to
clean the transparent panel on the media cover so that you can see the media
supply inside the printer when the cover is closed.