3. Remove the media from the paper path and the ribbon (if installed) from
the TTR supply and takeup hubs.
4. Use a cotton swab moistened with alcohol to remove any dirt, adhesive, or
debris from the print surface on the bottom of the printhead.
I n t e
r m e
c
3 6
0 0
Thermal
printhead
5. Wait 5 to 10 seconds for the print surface to dry. Reload the media (and
ribbon if used).
6. Engage the printhead by rotating the head lift lever counterclockwise until
it locks in place.
7. If you are finished cleaning, install the media cover.
Preventive Maintenance
3600M.012
2
2-7