Initial Set Mode - Icom IC-F7000 Instruction Manual

■ Initial set mode

Initial set mode operation is used for programming in-
frequently changed values, conditions or functions.
D D Entering set mode
q Turn the transceiver power OFF, if the transceiver is
powered ON.
w While pushing [OK ≈ ≈ ], push [I/O] to turn the trans-
ceiver power ON to enter initial set mode.
• Setting menu which are 7 groups appears.
e Push [ ∫ ∫ ]/[ √ √ ] to select the desired group.
SET-MODE
--CH-LIST- å
--ID-LIST
--I/O
è-SCAN
Push √ or ∫
é-SELCALL--å
--ALE
--GENERAL
r Push [OK ≈ ≈ ] to edit the selected setting group.
(Eg. select 'GENERAL')
é-SELCALL----
--ALE--------
--GENERAL----å
--I/O--------
è-SCAN-------
t Push [ ∫ ∫ ]/[ √ √ ] to select the desired item of the group.
(Eg. select 'COMP')
GENERAL----
--DISP-TYPE--RX-TX
--COMMENT----ON
--COMP-------ç-ON-å
è-CLOCK------12:00
y Push [Ω Ω CLR]/[OK ≈ ≈ ] to set the values or condi-
tions for the selected item.
u After all setting is finished, turn the power OFF and
ON again to exit the Initial set mode.
SET MODE
[I/O]
[∫]/[√]
[Ω CLR]/[OK ≈]
6
[ OK ≈ ]
6
40