Channel/Id Programming; Programming A Channel - Icom IC-F7000 Instruction Manual

5

CHANNEL/ID PROGRAMMING

■ Programming a channel

The IC-F7000 has up to 500 programmable channels
(400: regular, 100: ALE) with channel comment capa-
bility of up to 15 alphanumeric characters.
D D Editing a channel
q While pushing and holding [OK ≈ ≈ ], turn power ON
to enter the Initial set mode.
[I/O]
w Push [OK ≈ ≈ ] to edit 'CH LIST.'
SET-MODE
--CH-LIST--å
--ID-LIST-
--I/O
è-SCAN
e Push [ ∫ ∫ ]/[ √ √ ] to select the desired channel or
'<add>,' then push [OK ≈ ≈ ].
• Push [Ω Ω CLR] to return the set mode menu.
• "*" marked channel is restricted for programming. Ask
your dealer.
--<add>---------------å
----12-RADTEL
-*--13-RADTEL
----14-RADTEL
è---15-RADTEL
31
[∫]/[√]
[Ω CLR]/[OK ≈]
• When existing channel is selected
r Push [ ∫ ∫ ]/[ √ √ ] to select the item or push
[Ω Ω CLR]/[OK ≈ ≈ ] to set the values or conditions for
each memory channel contents "Comment," "RX
frequency," "TX frequency," "Call Type," "Scan
group," "Filter."
ç---CH-12
-----RADTEL
---TX-03.760.0
---RX-03.760.0
è-MODE-USB
Push √ or ∫
é-TYPE-ç-TELCALL-å
--FIL--WIDE
--SCAN-2
--DELETE-NO
• When <add> is selected
r Edit a channel number by 10-keypad, then push
[OK ≈ ≈ ] to enter the channel programming.
• If existing channel number is entered, this operation se-
lects a desired channel directly.
ç---CH-____
-----RADTEL
---TX-03.760.0
---RX-03.760.0
è-MODE-USB