Microphone (Hm-155) - Icom IC-F7000 Instruction Manual

■ Microphone (HM-155)

q PTT SWITCH [PTT]
Push and hold to transmit; release to receive.
w UP/DOWN SWITCHES [U U P P ]/[D D N N ]
Push either switch to change the operating channel,
frequency, etc.
e UP/DOWN LOCK SWITCH
Slide to toggle [UP]/[DN] switches function ON and
OFF.
D D Keypad
[1 1 0 0 - - k k e e y y ]
➥ Inputs numeral for the TEL number, ID number,
channel number input, etc.
➥ Inputs numeral and alphabet (some symbol) for
the message input of the Page call function or
channel comment input, etc.
• Available characters are shown at page 2.
[Ω Ω CLR]
CLR
➥ Push momentarily to move the cursor
backward.
➥ Push momentarily to decrease the set-
ting value for the set mode.
➥ Push momentarily to indicate receive
message when standby condition.
[OK ≈ ≈ ]
OK
➥ Push to move the cursor forward.
➥ Push to increase the setting value for
the set mode.
➥ Push to indicate receive message when
standby condition.
➥ Push to fix input of channel comments.
PANEL DESCRIPTION
mic
1 2 3
TUNE
q
4 5 6
SCAN
[PTT]
7 8 9
MUTE
CLR 0 OK
CALL
[TUNE]
➥ Push for 1 sec. to start manual tune the
TUNE
optional antenna tuner.
• "Tuning" appears while tuning.
• When the tuner cannot tune the antenna,
the tuning circuit is bypassed automatically
after 20 sec.
➥ Push momentarily to toggle the optional
automatic antenna tuner (AT-140 only)
ON and OFF (bypass).
[SCAN]
➥ Push to start and stop the scanning.
SCAN
[MUTE]
➥ Push to select the mute types. Available
MUTE
types are voice mute, signal level mute
(level 1—100), call mute or mute OFF.
• When select the mute type, transceiver
emits different conformation beep for each
type.
OFF—1 long beep,
Call mute—1 short beep,
Signal level mute—2 short beeps,
Voice mute—3 short beeps
[CALL]
➥ Push to enter the Call menu.
CALL
• Push again to exit the Call menu.
➥ Push for 1 sec. to transmit the Call.
1
w [UP]/[DN]
ON
e
OFF
[LOCK]
10-key
1
4