Icom IC-F7000 Instruction Manual page 20

3
RECEIVE AND TRANSMIT
■ Functions for receive (Continued)
ï RIT function
The RIT (Receive Incremental Tuning) function com-
pensates for off-frequencies of communicating sta-
tions. The function shifts the receive frequency up to
±150 Hz without moving the transmit frequency.
[I/O]
ï Preamp
The preamp amplifies received signals in the front
end circuit to improve the S/N ratio and sensitivity.
Turn this function ON when receiving weak signals.
• Channel indication (p. 7)
q While pushing and holding [OK ≈ ≈ ], turn power ON
to enter the Initial set mode.
SET-MODE
--CH-LIST----å
--ID-LIST----
--I/O--------
è-SCAN-------
w Push [√ √ ] to select 'GENERAL,' then push [OK ≈ ≈ ].
é-SELCALL----
--ALE--------
--GENERAL----å
--I/O--------
è-SCAN-------
e Push [√ √ ] to select 'PRE AMP,' then push [Ω Ω CLR]
or [OK ≈ ≈ ] to turn the preamp function ON.
é-PASSWORD---LOCK
--PRE-AMP----ç-ON-å
--VOL-MIN----0
--COMP-------ç-ON-å
è-CLOCK------12:00
r Turn power OFF and ON.
17
[∫]/[√]
[Ω CLR]/[OK ≈]
q Push [I/O] to enter the Quick set mode while trans-
ceiver's power is ON.
w Push [∫ ∫ ] or [√ √ ] to select 'RIT.'
é-SQL-LV----30
--FILTER----WIDE
--RIT-------ç-0-å
--MODE------USB
--BEEP-LV---5
e Push [Ω Ω CLR] or [OK ≈ ≈ ] to tune the frequency.
• The transmit frequencies are not shifted.
r Push [I/O] to exit the Quick set mode and return to
the normal operating mode.
When cancelling the RIT function, tune the 'RIT' in
the Quick set mode to '0.'
[I/O]
• Frequency indication (p. 7)
q Push [I/O] to enter the Quick set mode while trans-
ceiver's power is ON.
Q-SET-MODE(VFO)
--MODE------ç-USB----å
--SQL-LV----30
--PRE-AMP---ON
è-RF-GAIN---9
w Push [√ √ ] to select 'PRE AMP,' then push [Ω Ω CLR]
or [OK ≈ ≈ ] to turn the preamp function ON.
Q-SET-MODE(VFO)
--MODE------USB
--SQL-LV----30
--PRE-AMP---ç-ON-å
è-RF-GAIN---9
e Push [I/O] to exit the Quick set mode and return to
the normal operating mode.
[∫]/[√]
[Ω CLR]/[OK ≈]