Icom IC-F7000 Instruction Manual page 44

6
SET MODE
D D Setting CH LIST (pgs. 31, 32)
q Push [OK ≈ ≈ ] to edit 'CH LIST.'
SET-MODE
--CH-LIST--å
--ID-LIST-
--I/O
è-SCAN
w Push [ ∫ ∫ ]/[ √ √ ] to select the desired channel or
'<add>' for new entry, then push [OK ≈ ≈ ].
• Push [Ω Ω CLR] to return the set mode menu.
• "*" marked channel is restricted for programming or
changing. Ask your dealer.
--<add>---------
----12-RADTEL---------å
-*--13-RADTEL
----14-RADTEL
è---15-RADTEL
D D Setting ID LIST (pgs. 33–35)
q Push [ √ √ ] to select 'ID LIST,' then push [OK ≈ ≈ ] to
edit 'ID LIST.'
SET-MODE
--CH-LIST-
--ID-LIST--å
--I/O
è-SCAN
w Push [ ∫ ∫ ]/[ √ √ ] to select the desired call type, then
push [OK ≈ ≈ ].
• Push [Ω Ω CLR] to return the set mode menu.
--SELCALL-----å
--TEL-NO.
--ALE
----CH-14-RADTEL
è---CH-15-RADTEL
41
[∫]/[√]
[Ω CLR]/[OK ≈]
[∫]/[√]
[Ω CLR]/[OK ≈]
e Push [ ∫ ∫ ]/[ √ √ ] to select the item or push [Ω Ω
CLR]/[OK ≈ ≈ ] to set the values or conditions for
each memory channel contents "Comment," "RX
frequency," "TX frequency," "Call Type," "Scan
group," "Filter."
ç---CH-12
-----RADTEL
---TX-03.760.0
---RX-03.760.0
è-MODE-USB
Push √ or ∫
é-TYPE-ç-TELCALL-å
--FIL--WIDE
--SCAN-2
--DELETE-NO
r After all setting is finished, turn power OFF and ON
again to exit the Initial set mode.
e Push [ ∫ ∫ ]/[ √ √ ] to select the desired ID channel, then
push [OK ≈ ≈ ].
• Push [Ω Ω CLR] to return the call selection menu.
• No displayed channel is a blank channel.
• ID programming screen appears.
é--1-2999-Easten----å
---2-3999-NorthEast-
---3-6999-Western---å
---4-6999-Western
è--5-7999-NorthWest
r Push [ ∫ ∫ ]/[ √ √ ] to select the item or push
[Ω Ω CLR]/[OK ≈ ≈ ] to set the ID list contents.
ç---ID-1022
------NO.x0022
----CH-12-320
--DELETE-NO
----åKEY-PUSH-&-HOLD
t After all setting is finished, turn power OFF and ON
again to exit the Initial set mode.