Netconf Over Ssh Configuration Example With Password Authentication; Network Requirements - HP 5920 Series Configuration Manual

# Create a local device management user named client001 with the plaintext password aabbcc,
the service type ssh, and the user role network-admin.
[SwitchB] local-user client001 class manage
[SwitchB-luser-manage-client001] password simple aabbcc
[SwitchB-luser-manage-client001] service-type ssh
[SwitchB-luser-manage-client001] authorization-attribute user-role network-admin
[SwitchB-luser-manage-client001] quit
# Configure an SSH user client001 with service type scp and authentication method password.
[SwitchB] ssh user client001 service-type scp authentication-type password
2. Configure an IP address for VLAN-interface 2 on the SCP client.
<SwitchA> system-view
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address 192.168.0.2 255.255.255.0
[SwitchA-Vlan-interface2] quit
[SwitchA] quit
3. Connect to the SCP server, download the file remote.bin from the server, and save it locally with
the name local.bin.
<SwitchA> scp 192.168.0.1 get remote.bin local.bin
Username: client001
Connecting to 192.168.0.1 port 22.
The server is not authenticated. Continue? [Y/N]:y
Do you want to save the server public key? [Y/N]:n
client001@192.168.0.1's password:
remote.bin
NETCONF over SSH configuration example with
password authentication
This example is available in Release 231 1P04 and later versions.
The device in the configuration example is in non-FIPS mode.
When you configure NETCONF-over-SSH on a device that operates in FIPS mode, follow these
restrictions and guidelines:
The modulus length of the key pair must be 2048 bits.
•
• When the device acts as a NETCONF-over-SSH server, only RSA and ECDSA key pairs are
supported. Do not generate a DSA key pair on the NETCONF-over-SSH server.

Network requirements

As shown in
The switch uses local password authentication.
•
The client's username and password are saved on the switch.
•
Establish a NETCONF-over-SSH connection between the host and the switch, so that you can log in to the
switch to perform NETCONF operations.
Figure 101:
100% 2875
306
2.8KB/s 00:00