Installing The Os And Bundled Software - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual

5. Copy to a formatted floppy disk the files in either of the following relevant folders, based on the
environment of the operating system to be installed.
for x86: C:\Program Files\Emulex\AutoPilot Installer\Drivers\Storport\x86
for x64: C:\Program Files\Emulex\AutoPilot Installer\Drivers\Storport\x64
Notes
 The paths above assume that the extraction destination is the default folder of C:\Program Files\Emulex.
If the extraction destination is changed, replace this part with the changed path. The above created FD is
the FC card driver FD.
 For a new installation of Windows Server 2003 SP2, you need to create the driver FD with v1.30a6 or
v1.30a9 of the FC card driver. The driver FD is required for operating system installation using FC card
driver v2.01a4 or later. After completing the operating system installation, use v2.01a4 or a later version
of the installation module to update the driver.

4.2.3 Installing the OS and bundled software

Use SVIM from the remote storage or the built-in DVD drive to install the OS and bundled software.
Use the following procedure.
1. Make the setting for booting the partition from the built-in DVD drive.
Remarks
To install Windows Server 2003 SP2 from the built-in DVD drive, be sure to set "Legacy Boot" as
described in TABLE 4.2 [Change Boot Order] menu. "UEFI : Embedded DVD/CD" is unsupported.
1. After powering on the partition, press any key ([Space] key, for example) other than the [Enter] key
while the FUJITSU logo is displayed, to display the Boot Manager Front Page.
2. Select the following items from the menu in the following order, on the Boot Manager Front Page:
[Boot Maintenance Manager] - [Boot Options] - [Change Boot Order] - [Change the order]
3. Specify [UEFI:DVD/CD 0] as the highest-priority device to boot from remote storage.
118