Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual page 141

7. Click [Install].
Installation begins.
Replace the media with the operating system installation media according to the SVIM instructions.
8. Install the FC card driver.
When the following message is displayed, press the [S] key.
To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use with
Windows, including those for which you have a device support disk from a mass storage device
manufacturer, press S.
When the following message is displayed, insert the previously created FC card driver FD into the remote
storage of the partition, and then press the [Enter] key.
Please insert the disk labeled Manufacturer-supplied hardware support disk into Drive A:
Then, the following message is displayed.
You have chosen to configure a SCSI Adapter for use with Windows, using a device support disk
provided by an adapter manufacturer. Select the SCSI Adapter you want from the following list, or
press ESC to return to the previous screen.
9. Select the following FC card.
Select [Emulex LPe11002] since the MC-0JFC21 card is the Emulex Lpe11002 PCIe-Fibre Channel
HBA.
10. Follow the instructions on the screen to perform the installation.
When a message telling you to insert the driver FD is displayed during the installation, insert the
previously created driver FD into the remote storage, and then press the [Enter] key.
11. Follow the instructions from the setup program to continue the installation work.
Note
A warning message about a restart by the setup program appears during the installation process. At that time,
wait for the automatic restart.
For a SAN boot configuration, apply the following hot fix related to the Storport driver:
120