Recording The Wwn Of The Fc Port - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual

2.3.10 Recording the WWN of the FC port

According to the design drawing of the SAN boot environment, write down the WWN (World Wide Name),
specific address information assigned to the FC port of the FC card of each server.
Confirm the WWN with [Port Name] in the [Adapter Selection] menu. The menu appears after the [Emulex
Configuration Utility] restart.
FIGURE 2.84 [Adapter Selection] menu
Remarks
If you are updating FC card firmware (e.g., Boot BIOS), check the WWN after the firmware update.
To clearly identify the mounting location of the FC card, record the host name (the one that identifies the
PRIMEQUEST 1000 series server), mounted card, mounting slot location, BUS number, and DEV number.
For the BUS number and slot number, check the BUS number and slot number of the target HBA from the
[IOB] menu and [PCI_Box] menu of the MMB Web-UI.
The BUS number appears as the middle number of the three numbers delimited by slash in the [Seg/Bus/Dev]
item.
The following example shows how the WWNs are recorded.
81