FIGURE 3.19
Remarks
Immediately after the settings made in the following operations, the Scan for Fibre Devices operation may
not correctly display Fibre Device information:
- 3.2.6
Enabling BIOS
- 3.2.7
Configuring the DCBX (Data Center Bridging Exchange) mode
- 3.2.8
Configuring the converged network adapter and boot parameters
In such cases, execute the reset command with the UEFI Shell, or select [Reset] from the [Power Control]
window of the MMB Web-UI. The system is restarted. Make settings again as described in 3.2.9 Boot
device setting.
If the expected Fibre Device is still not displayed, there is a possibility that the SAN storage settings,
FCoE switch settings, or physical connection is incorrect. Confirm them once again.
3. Select [Go to Configuration Main Menu], and then press the [Enter] key.
Boot device setting (2)
96