Configuring The Uefi - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual
San boot environment configuration manual
Hide thumbs
Also See for PRIMEQUEST 1000 Series:
- User manual (905 pages) ,
- Tool reference (578 pages) ,
- Installation manual (344 pages)
Table of Contents
Advertisement
5.2.4 Configuring the UEFI
Start the Boot Manager front page. Select [Boot Maintenance Manager] - [Boot Options]- [Change Legacy
HDD Boot Priority]. Then, assign the boot disk that was built on the SAN storage unit to the top position.
The procedure for making this setting is as follows.
Starting the Boot Manager front page
1.
Power on the target partition.
2.
After one or two minutes, the window shown below appears. Press any key ([Space] key, for
example) other than the [Enter] key while the FUJITSU logo is displayed.
FIGURE 5.4
Logo at startup
133
Advertisement
Table of Contents
