Making Various Settings After Installation - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual

4. Specify [Commit Changes and Exit] - [Reset System] to reboot the partition.
2. Insert ServerView Suite DVD1 into the DVD drive. Then, power on the partition.
3. After a moment, the language selection window appears. Select [English] for installation in English.
4. In the initially displayed window, click the [Next] button.
5. Select [Deployment] in the [Welcome to ServerView Installation Manager] window.
6. Select an installation mode and the operating system to be installed. Then, set up the operating system.
7. Click [Install]. Installation begins.
Replace the media with the operating system installation media according to the SVIM instructions.

6.1.3 Making various settings after installation

Make various settings by referring to CHAPTER 5 Work after Operating System Installation (PRIMEQUEST
1800E2).
Remarks
For details on how to obtain the driver and utility of the Fibre Channel card, contact the distributor where you
purchased your product, or your sales representative.
1. Install the ETERNUS multipath driver. For details on how to install the driver, see the manual of the
multipath driver.
Remarks
At this time, leave the secondary FC path cable disconnected.
2. Restore the multipath connection.
After completing the installation of the ETERNUS multipath driver, shut down the operating system. After
powering off the partition, reconnect the cable of the FC path that has been disconnected.
145