Settings On The Converged Network Adapter; Uefi Driver Settings On The Converged Network Adapter; Adapter - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual

CHAPTER 3
This chapter describes settings to be made on the PRIMEQUEST 1000 series server to start the system from a
LUN of the SAN storage unit in the FCoE SAN boot environment.
3.1

UEFI Driver Settings on the Converged Network Adapter

To have the system start from a LUN of the SAN storage unit in the SAN boot environment, the operation
described below is required for all of the HBAs to be used for starting the system.
Executing this operation registers in the HBA the SAN storage unit LUN from which the system is to be started.
This section uses examples of screen displays resulting from the use of UEFI driver version 5.01A13.
All screenshots appearing below are display examples whose contents vary depending on the system
configuration, etc.
Notes
- If the UEFI boot menu has the setup menu, select the setup menu and proceed to the work described in 3.2.2
Starting the HBA setup utility.
- Different versions of the converged network adapter firmware cannot be mixed in a single partition.
Moreover, different versions of the UEFI driver of the converged network adapter cannot be mixed in a
single partition. If you have different versions of the firmware or UEFI driver of the converged network
adapter, install the same version of the firmware or UEFI driver, respectively.
Settings on the Converged
Network Adapter
83