Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual page 177

- All SAS disk names are preceded by two slashes ("//").
- Boot disks are at the top and SAS disks at the bottom of the order.
FIGURE 6.12 [Change Legacy HDD Boot Priority] screen (for confirming SAS boot)
 Starting the partition and confirming the built-in disk
After completing the UEFI setting, start the partition.
After starting the partition, execute the following command to confirm the difference between the
current state and the state in which the built-in disk had not been mounted yet.
# ls -l /dev/disk/by-id
The disk that was confirmed not to exist before the addition of the built-in disk is the added built-in disk.
Creating partitions of the built-in disk

Create disk partitions in the built-in disk, and create a swap file system and other necessary files.
Remarks
Fujitsu recommends you to place the swap partition in the built-in hard disk. For details, contact
your sales representative or a field engineer.
156