Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual page 39

FIGURE 2.5
Note
Note the following points when using UEFI driver version 4.12a7 or later to set a SAN boot configuration on
the FC card. (In the above example, Emulex Configuration Utility Ver. is 4.12a7.)

Before deleting a registered boot entry with the Delete Boot Device process, be sure to change the BIOS
enable setting (Set Boot from SAN) to Disable.

Executing the Delete Boot Device process with Enable as the BIOS enable setting (Set Boot from SAN)
may render Emulex Configuration Utility inoperable on rare occasions. In such cases, select [Reset] from
the [Power Control] window of the MMB Web-UI to restart the system. Then, make the settings on the
FC card again.
[Device List] (version displayed)
18