Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual page 98

15. For a multipath configuration, make the settings described in the sections from 2.3.2 Starting the HBA setup
utility to 2.2.7 Speed and Topology settings for all the HBAs connected to the SAN storage unit LUN from
which the system is started. Also, after installing the operating system and multipath driver, perform the
operation described in 2.2.8 Boot device setting for all the HBAs used to start the system.
After finishing all the settings, select [Exit Emulex HBA Configuration Utility], and then press the [Enter]
key to return to the Device Manager menu.
FIGURE 2.79
Note
If "Save changes? (Y/N)" appears following the operations below, press the [N] key. You need not perform
another operation here because the [Commit Changes] or [Discard Changes] operation from the menu
completes the task of changing or discarding settings.
Select the relevant item from the [Delete Boot Device] or [Change Boot Device Order] menu.

Select [Commit Changes] or [Discard Changes].

Go back to the [Delete Boot Device] or [Change Boot Device Order] menu.
Boot device setting (15)
77