Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual page 151

Note
Although the downloaded binary file has descriptions referring to PRIMERGY, you can use the driver and
utility for the PRIMEQUEST 1000 series too.
3. Copy the downloaded file to any directory of the PRIMEQUEST 1000 series server, and extract files.
4. The following files are extracted:
FIGURE 5.2
For details on how to install the SNIA HBA API Library, see readme.txt that has been extracted in
the HBA_API_LIB folder.
5. Install the ETERNUS multipath driver. For details on how to install the driver, see the manual of the
multipath driver.
Remarks
At this time, leave the secondary FC path cable disconnected.
6. Restore the multipath connection.
After completing the installation of the ETERNUS multipath driver, shut down the operating system. After
powering off the partition, reconnect the cable of the FC path that has been disconnected.
Remarks
Use the following procedure to confirm a multipath configuration.
1. Set the HBA UEFI driver. For details, see CHAPTER 2 Settings on the Fiber Channel Card (FC
Card).
2. Start at the Boot Manager Front Page. Display the following screens in the order given: [Boot
Maintenance Manager] - [Boot Options] - [Change Legacy HDD Boot Priority].
3. Confirm that multiple disks with multiple HBAs are recognized, as shown in the following figure.
If the multiple disks are not recognized, reconfirm that there is no problem in how the multipath
connections were restored.
SNIA HBA API Library (extracted files)
130