5.
Execute [Commit Changes and Exit] to exit.
6.
Open [Change Legacy HDD Boot Priority] again for confirmation.
7.
Confirm the following:
- All SAS disk names are preceded by two slashes ("//").
- Boot disks are at the top and SAS disks at the bottom of the order.
FIGURE 5.13
Starting the partition and confirming the built-in disk
After completing the UEFI setting, start the partition.
After starting the partition, execute the following command to confirm the difference between the
current state and the state in which the built-in disk had not been mounted yet.
# ls -l /dev/disk/by-id
The disk that was confirmed not to exist before the addition of the built-in disk is the added built-in disk.
[Change Legacy HDD Boot Priority] screen (confirming SAS boot)
141