13. Select [Back to Display Adapters and RECONNECT DEVICES], and then press the [Enter] key to return to
the higher menu.
FIGURE 3.30
14. For a multipath configuration, make the settings described in the sections from 3.2.2 Starting the HBA setup
utility to 3.2.8 Configuring the converged network adapter and boot parameters for all the HBAs connected
to the SAN storage unit LUN from which the system is started. Also, after installing the operating system
and multipath driver, perform the operation described in 3.2.9 Boot device setting for all the HBAs used to
start the system.
After finishing all the settings, select [Exit Emulex HBA Configuration Utility], and then press the [Enter]
key to return to the Device Manager menu.
Boot device setting (13)
103