Icom IC-7800 Instruction Manual page 179

■ Others set mode
Sets the repeating rate for the connected keyboard
within 2.0 to 30.0 cps.
When a key of the connected keyboard is held down,
the character is repeatedly input with the set speed.
Sets IP address for the IC-7800 when connecting to
your PC or LAN (Local Area Network) through the
Ethernet connector.
Sets subnet mask for the IC-7800 when connecting
to your PC or LAN (Local Area Network) through the
Ethernet connector.
Sets the default gateway of the router that you want
to connect the IC-7800 to.
Only when you configure the remote control sys-
tem using an optional RS-BA1 through the Inter-
net, you need this setting.
Selects the remote control capability ON or OFF.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this set-
ting.
Sets the Control port of the IC-7800 by accessing
from the remote station.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this set-
ting.
(continued)
(default: 10.9 cps)
*cps=character per second
(default : OFF)
Turn the transceiver power OFF then ON to make the
setting effective. See page 16-7 for details.
Turn the transceiver power OFF then ON to make the
setting effective. See page 16-7 for details.
Turn the transceiver power OFF then ON to make the
setting effective.
Turn the transceiver power OFF then ON to make the
setting effective.
Turn the transceiver power OFF then ON to make the
setting effective.
12-23
12
SET MODE