Icom IC-7800 Instruction Manual page 89

D Scope set mode (continued)
Turn the peak level holding function ON or OFF.
Select the center frequency of the spectrum scope in-
dication (center mode only).
Select the outline indication of the waveform for the
spectrum scope.
Set the waveform color for the currently received sig-
nals.
Set the waveform outline color for the currently re-
ceived signals.
Set the waveform color for the receiving signals max-
imum level.
Set the waterfall display to ON or OFF.
FUNCTIONS FOR RECEIVE
• Filter center
• Carrier Point Center
• Carrier Point Center (Abs. Freq.)
• Fill : The waveform is described by only
the color.
• Fill + Line : The waveform is described by the
color and outline.
• The color is set in RGB format.
• Push [F-3•Ω ≈] to select R (Red), G (Green) and B
(Blue), and rotate the ratio from 0 to 255 range.
• The set color is indicated in the box beside the RGB
scale.
• The color is set in RGB format.
• Push [F-3•Ω ≈] to select R (Red), G (Green) and B
(Blue), and rotate the ratio from 0 to 255 range.
• The set color is indicated in the box beside the RGB
scale.
• The color is set in RGB format.
• Push [F-3•Ω ≈] to select R (Red), G (Green) and B
(Blue), and rotate the ratio from 0 to 255 range.
• The set color is indicated in the box beside the RGB
scale.
• ON : Displays the waterfall of the spec-
trum scope.
• OFF : Does not display the waterfall.
5-5
: Shows the selected filter's center
frequency at the center.
: Shows the selected operating
mode carrier point frequency at
the center.
: In addition to the carrier point
center setting above, the actual
frequency is displayed for the
bottom of the scope.
5