Unusual Network Activity; General Problems - HP ProCurve 6120G/XG Configuration Manual

Procurve series 6120 blade switches management and configuration guide
Hide thumbs Also See for ProCurve 6120G/XG:
Table of Contents

Advertisement

Unusual Network Activity

Network activity that fails to meet accepted norms may indicate a hardware
problem with one or more of the network components, possibly including the
switch. Such problems can also be caused by a network loop or simply too
much traffic for the network as it is currently designed and implemented.
Unusual network activity is usually indicated by the LEDs on the front of the
switch or measured with the switch console interface or with a network
management tool such as ProCurve Manager. Refer to the Installation and
Getting Started Guide you received with the switch for information on using
LEDs to identify unusual network activity.
A topology loop can also cause excessive network activity. The Event Log
"FFI" messages can be indicative of this type of problem.

General Problems

The network runs slow; processes fail; users cannot access servers or
other devices. Broadcast storms may be occurring in the network. These
may be due to redundant links between nodes.
If you are configuring a port trunk, finish configuring the ports in the
trunk before connecting the related cables. Otherwise you may inad­
vertently create a number of redundant links (i.e. topology loops) that
will cause broadcast storms.
Turn on Spanning Tree Protocol to block redundant links (i.e.
topology loops)
Check for FFI messages in the Event Log.
Duplicate IP Addresses. This is indicated by this Event Log message:
ip: Invalid ARP source: IP address on IP address
where: both instances of IP address are the same address, indicating the
switch's IP address has been duplicated somewhere on the network.
Duplicate IP Addresses in a DHCP Network. If you use a DHCP server
to assign IP addresses in your network and you find a device with a valid IP
address that does not appear to communicate properly with the server or other
devices, a duplicate IP address may have been issued by the server. This can
occur if a client has not released a DHCP-assigned IP address after the
intended expiration time and the server "leases" the address to another device.
Troubleshooting
Unusual Network Activity
C-9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 6120xgProcurve 6120 series

Table of Contents