HP ProCurve 6120G/XG Configuration Manual page 393

SNMP Notification. You can enable the switch to send a notification to any
configured SNMP trap receiver(s) when the switch detects a remote LLDP
data change on an LLDP-enabled port (page 13-54).
Per-Port (Outbound) Data Options. The following table lists the
information the switch can include in the per-port, outbound LLDP packets it
generates. In the default configuration, all outbound LLDP packets include
this information in the TLVs transmitted to neighbor devices. However, you
can configure LLDP advertisements on a per-port basis to omit some of this
information (page 13-56).
Table 13-3. Data Available for Basic LLDP Advertisements
Data Type Configuration
Time-to-Live See note 1.
2, 6
Chassis Type
6
Chassis ID
3, 6
Port Type
6
Port Id
Remote Management
Address
4, 6
Type
4
Address Default or
Configured
6
System Name Enable/Disable
6
System Description Enable/Disable
6
Port Description Enable/Disable
System capabilities Enable/Disable
5, 6
supported
System capabilities Enable/Disable
5, 6
enabled
Default
Options
120 Seconds
N/A Always Enabled Indicates the type of identifier used for Chassis ID.
N/A Always Enabled Uses base MAC address of the switch.
N/A Always Enabled Uses "Local", meaning assigned locally by LLDP.
N/A Always Enabled Uses port number of the physical port. In the switches
N/A Always Enabled Shows the network address type.
Uses a default address selection method unless an optional address is
configured. See "Remote Management Address" on page 13-46.
Enabled
Enabled
Enabled
Enabled
Enabled
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Description
The length of time an LLDP neighbor retains the advertised
data before discarding it.
covered in this guide, this is an internal number reflecting
the reserved slot/port position in the chassis. For more
information on this numbering scheme, refer to figures D-2
and D-3 in Appendix D, "MAC Address Management" of the
Management and Configuration Guide for your switch.
Uses the switch's assigned name.
Includes switch model name and running software version,
and ROM version.
Uses the physical port identifier.
Identifies the switch's primary capabilities (bridge, router).
Identifies the primary switch functions that are enabled,
such as routing.
13-45