Spanning-Tree Protocol (Mstp) And Fast-Uplink Problems - HP ProCurve 6120G/XG Configuration Manual

Troubleshooting
Unusual Network Activity
Spanning-Tree Protocol (MSTP) and Fast-Uplink
Problems
C a u t i o n
If you enable MSTP, it is recommended that you leave the remainder of the
MSTP parameter settings at their default values until you have had an oppor­
tunity to evaluate MSTP performance in your network. Because incorrect
MSTP settings can adversely affect network performance, you should avoid
making changes without having a strong understanding of how MSTP oper­
ates. To learn the details of MSTP operation, refer to the IEEE 802.1s standard.
Broadcast Storms Appearing in the Network. This can occur when
there are physical loops (redundant links) in the topology.Where this exists,
you should enable MSTP on all bridging devices in the topology in order for
the loop to be detected.
STP Blocks a Link in a VLAN Even Though There Are No Redundant
Links in that VLAN. In 802.1Q-compliant switches MSTP blocks redundant
physical links even if they are in separate VLANs. A solution is to use only one,
multiple-VLAN (tagged) link between the devices. Also, if ports are available,
you can improve the bandwidth in this situation by using a port trunk. Refer
to "Spanning Tree Operation with VLANs" in the chapter titled "Static Virtual
LANs (VLANs)" in the Advanced Traffic Management Guide for your switch.
Fast-Uplink Troubleshooting. Some of the problems that can result from
incorrect usage of Fast-Uplink MSTP include temporary loops and generation
of duplicate packets.
Problem sources can include:
■
■
■
■
■
■
C-16
Fast-Uplink is configured on a switch that is the MSTP root device.
Either the or the
Hello Time
more switches. Return the
values (2 seconds and 20 seconds, respectively, on a switch).
A "downlink" port is connected to a switch that is further away (in hop
count) from the root device than the switch port on which fast-uplink
MSTP is configured.
Two edge switches are directly linked to each other with a fast-uplink
(Mode = Uplink ) connection.
Fast uplink is configured on both ends of a link.
A switch serving as a backup MSTP root switch has ports configured for
fast-uplink MSTP and has become the root device due to a failure in the
original root device.
setting (or both) is too long on one or
Max Age
and Max Age settings to their default
Hello Time