Managing Startup-Config Files In The Switch - HP ProCurve 6120G/XG Configuration Manual

Switch Memory and Configuration
Multiple Configuration Files
ProCurve(config)# startup-default pri config minconfig
ProCurve(config) # startup-default sec config newconfig.
Overriding the Default Reboot Configuration Policy. This command
provides a method for manually rebooting with a specific startup-config file
other than the file specified in the default reboot configuration policy.
Syntax:
Using Reload To Reboot From the Current Flash Image and Startup-
Config File.
Syntax:

Managing Startup-Config Files in the Switch

Command
rename config < current-filename > < newname-str >
copy config < source-filename > config < dest-filename >
erase config < filename > | startup-config
Erase startup-config using the front-panel Clear + Reset Buttons
6-32
boot system flash < primary | secondary > config < filename >
Specifies the name of the startup-config file to apply for the
immediate boot instance only. This command overrides the
current reboot policy.
reload
This command boots the switch from the currently active flash
image and startup-config file. Because reload bypasses some
subsystem self-tests, the switch boots faster than if you use a
boot command.
Note: To identify the currently active startup-config file, use
the show config files command.
Page
6-33
6-33
6-35
6-37