Copying Command Output To A Destination Device; Copying Event Log Output To A Destination Device - HP ProCurve 6120G/XG Configuration Manual

Copying Command Output to a Destination Device

Syntax: copy command-output < "cli-command" > tftp < ip-address > < filepath­
For example, to use Xmodem to copy the output of show config to a serially
connected PC:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-11. Example of Sending Command Output to a File on an Attached PC
N o t e
The command you specify must be enclosed in double-quote marks.

Copying Event Log Output to a Destination Device

Syntax: copy event-log tftp < ip-address > < filepath_filename >
For example, to copy the event log to a PC connected to the switch:
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
filename >
copy command-output < "cli-command" > usb < filename >
copy command-output <"cli-command"> xmodem
These commands direct the displayed output of a CLI
command to a remote host, attached USB device, or to a serially
connected PC or UNIX workstation.
copy event-log usb < filename >
copy event-log xmodem <filename>
These commands copy the Event Log content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation.
File Transfers
Indicates the operation is finished.
A-31