Using Primary And Secondary Flash Image Options; Displaying The Current Flash Image Data - HP ProCurve 6120G/XG Configuration Manual

Switch Memory and Configuration

Using Primary and Secondary Flash Image Options

Using Primary and Secondary Flash
Image Options
The switches covered in this guide feature two flash memory locations for
storing switch software image files:
■
■
With the Primary/Secondary flash option you can test a new image in your
system without having to replace a previously existing image. You can also
use the image options for troubleshooting. For example, you can copy a
problem image into Secondary flash for later analysis and place another,
proven image in Primary flash to run your system. The switch can use only
one image at a time.
The following tasks involve primary/secondary flash options:
■
■
■
■

Displaying the Current Flash Image Data

Use the commands in this section to:
■
■
■
Viewing the Currently Active Flash Image Version. This command
identifies the software version on which the switch is currently running, and
whether the active version was booted from the primary or secondary flash
image.
Syntax:show version
6-14
Primary Flash: The default storage for a switch software image.
Secondary Flash: The additional storage for either a redundant or an
alternate switch software image.
Displaying the current flash image data and determining which switch
software versions are available
Switch software downloads
Replacing and removing (erasing) a local switch software version
System booting
Determine whether there are flash images in both primary and secondary
flash
Determine whether the images in primary and secondary flash are the
same
Identify which switch software version is currently running