HP ProCurve 6120G/XG Configuration Manual page 120

Switch Memory and Configuration
Configuration File Management
■
Booting the switch replaces the current running-config file with a new run­
ning-config file that is an exact copy of the current startup-config file.
N o t e
Any of the following actions boots the switch:
For more on reboots and the switch's dual-flash images, refer to "Using
Primary and Secondary Flash Image Options" on page 6-14.
Options for Saving a New Configuration. Making one or more changes
to the running-config file creates a new operating configuration. Saving a new
configuration means to overwrite (replace) the current startup-config file with
the current running-config file. This means that if the switch subsequently
reboots for any reason, it will resume operation using the new configuration
instead of the configuration previously defined in the startup-config file. There
are three ways to save a new configuration:
■
■
■
Note that using the CLI instead of the menu or web browser interface gives
you the option of changing the running configuration without affecting the
startup configuration. This allows you to test the change without making it
"permanent". When you are satisfied that the change is satisfactory, you can
make it permanent by executing the
suppose you use the following command to disable port 5:
ProCurve(config)# interface ethernet 5 disable
6-4
Startup-config File: Exists in flash (non-volatile) memory and is used
to preserve the most recently-saved configuration as the "permanent"
configuration.
• Executing the boot or the reload command in the CLI
Executing the boot command in the menu interface
•
• Pressing the Reset button on the front of the switch
• Removing, then restoring power to the switch
• Power-cycling or resetting via the OA
In the CLI: Use the
write memory
startup-config file with the contents of the current running-config file.
In the menu interface: Use the
running-config file and the startup-config file with the changes you have
specified in the menu interface screen.
In the web browser interface: Use the
appropriate button. This overwrites both the running-config file and the
startup-config file with the changes you have specified in the web browser
interface window.
command. This overwrites the current
Save command. This overwrites both the
button or other
[Apply Changes]
command. For example,
write memory