HP ProCurve 6120G/XG Configuration Manual page 215

==========================- CONSOLE - MANAGER MODE -========================
System Name : ProCurve
System Contact :
System Location :
Inactivity Timeout (min) [0] : 0
Inbound Telnet Enabled [Yes] : Yes
Time Sync Method [None] : TIMEP
TimeP Mode [Disabled] : Disabled
Tftp-enable [Yes] : Yes
Time Zone [0] : 0
Daylight Time Rule [None] : None
Actions-> Cancel
Figure 9-1. The System Information Screen (Default Values)
2. Press [E] (for Edit). The cursor moves to the System Name field.
3. Use [v] to move the cursor to the Time Sync Method field.
4. Use the Space bar to select SNTP, then press [v] once to display and move
5. Do one of the following:
Figure 9-2. Time Configuration Fields for SNTP with Broadcast Mode
Switch Configuration - System Information
Edit Save
to the SNTP Mode field.
Use the Space bar to select the Broadcast mode, then press
•
move the cursor to the Poll Interval field, and go to step 6. (For
Broadcast mode details, refer to "SNTP Operating Modes" on
page 9-3.)
Time Sync Method [None] : SNTP
SNTP Mode [Disabled] : Broadcast
Poll Interval (sec) [720] :
Tftp-enable [Yes] : Yes
Time Zone [0] : 0
Daylight Time Rule [None] : None
Use the Space bar to select the Unicast mode, then do the
•
following:
[>]
i. Press to move the cursor to the Server Address field.
ii. Enter the IP address of the SNTP server you want the switch to
use for time synchronization.
SNTP: Viewing, Selecting, and Configuring
MAC Age Time (sec) [300] : 300
Web Agent Enabled [Yes] : Yes
Server Address :
Jumbo Max Frame Size [9216] : 9216
Jumbo IP MTU [9198] : 9198
Time Protocol Selection Parameter
– TIMEP
– SNTP
Help – None
720
Time Protocols
[v]
to
9-7